Machinability investigations of hardened steel with biodegradable oil-based MQL spray system
Yazarlar (10)
Munish Kumar Gupta
Shandong University, Çin
Shandong University, Çin
Mozammel Mia
Imperial College London, İngiltere
Imperial College London, İngiltere
Muhammad Jamil
Nanjing University Of Aeronautics And Astronautics, Çin
Nanjing University Of Aeronautics And Astronautics, Çin
Rupinder Singh
Rayat Bahra University, Hindistan
Rayat Bahra University, Hindistan
Anil Kumar Singla
Sant Longowal Institute Of Engineering And Technology, Hindistan
Sant Longowal Institute Of Engineering And Technology, Hindistan
Qinghua Song
Shandong University, Çin
Shandong University, Çin
Zhanqiang Liu
Shandong University, Çin
Shandong University, Çin
Aqib Mashood Khan Nanjing University Of Aeronautics And Astronautics, Çin
M. Azizur Rahman
Ahsanullah University Of Science And Technology, Bangladeş
Ahsanullah University Of Science And Technology, Bangladeş
Prof. Dr. Murat SARIKAYA Sinop Üniversitesi, Türkiye
| Makale Türü | Özgün Makale (SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale) | ||
| Dergi Adı | International Journal of Advanced Manufacturing Technology (Q2) | ||
| Dergi ISSN | 0268-3768 Dergi Bilgileri (2020) | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | İngilizce | Basım Tarihi | 05-2020 |
| Cilt / Sayı / Sayfa | 108 / 3 / 735–748 | DOI | 10.1007/s00170-020-05477-6 |
| Makale Linki | http://link.springer.com/10.1007/s00170-020-05477-6 | ||
| UAK Araştırma Alanları |
Mühendislik
|
||
| Özet |
| Excessive use of coolant is undesirable in machining due to environmental consciousness; thereby, small but efficacious (improved thermal and tribological properties) amount of coolant has been implemented using minimum quantity lubrication (MQL). In this study, attention was focused on the experimental investigations on tool flank wear, chip morphology, surface roughness (Ra and Rq) and chip-tool interface temperature in the machining of hardened steel (~ 40 HRC) under olive oil-assisted MQL spray system. As investigating factors, the cutting speed, feed rate, and depth of cut were oriented by following the Taguchi orthogonal array. Then, the cooling and lubrication mechanism of the olive oil-assisted MQL system has been discussed. Outcomes of this study showed that MQL is capable of generating favorable machining outcomes, i.e., lower tool flank wear, reduced temperature, and surface roughness in … |
| Anahtar Kelimeler |
| Cutting temperature | MQL | Surface roughness | Tool wear | Turning |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Web of Science | 82 |
| Scopus | 98 |
| Google Scholar | 110 |