Analysis of hybrid HA/CNT suspended-EDM process and multiple-objectives optimization to improve machining responses of 316L steel
Yazarlar (8)
Md Al-Amin
Universiti Teknologi Petronas, Malezya
Universiti Teknologi Petronas, Malezya
Ahmad Majdi Abdul-Rani
Universiti Teknologi Petronas, Malezya
Universiti Teknologi Petronas, Malezya
Mohd Danish
University Of Jeddah, Suudi Arabistan
University Of Jeddah, Suudi Arabistan
Fatema Tuj Zohura
Sher-E-Bangla Agricultural University, Bangladeş
Sher-E-Bangla Agricultural University, Bangladeş
Saeed Rubaiee
University Of Jeddah, Suudi Arabistan
University Of Jeddah, Suudi Arabistan
Rasel Ahmed
Universiti Teknologi Petronas, Malezya
Universiti Teknologi Petronas, Malezya
Sadaqat Ali
National University Of Sciences And Technology, Pakistan
National University Of Sciences And Technology, Pakistan
Prof. Dr. Murat SARIKAYA Sinop Üniversitesi, Türkiye
| Makale Türü |
Özgün Makale
(SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale)
|
||
| Dergi Adı | Journal of Materials Research and Technology (Q1) | ||
| Dergi ISSN | 2238-7854 Dergi Bilgileri (2021) | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | İngilizce | Basım Tarihi | 12-2021 |
| Cilt / Sayı / Sayfa | 15 / 1 / 2557–2574 | DOI | 10.1016/j.jmrt.2021.09.074 |
| Makale Linki | http://dx.doi.org/10.1016/j.jmrt.2021.09.074 | ||
| UAK Araştırma Alanları |
Üretim Teknolojileri
|
||
| Özet |
| A low material erosion rate (MER) and a high roughness are challenges encountered when machining the biomaterials using the hydroxyapatite powder (HAp) suspended-electric discharge machining (EDM) process. Thus, a comprehensive analysis is needed as the required machining outputs are highly dependent on EDM process factors due to its stochastic behavior during the operation. In this context, the research aims at a detailed investigation of the EDM process factors on the machining responses and the feasibility of multiple additives mixed-EDM process needed for processing 316L steel to realize its full potential. To improve MER and reduce both surface roughness (SR) and tool erosion rate (TER), a hybrid of carbon nanotubes (CNT) and HAp supported EDM technique is employed. SEM and EDX analyses have validated the machined surface morphology and migration of the elements. The EDM … |
| Anahtar Kelimeler |
| 316L steel | Electro-discharge machining | Material erosion rate | Multi-objective spotted hyena optimizer | Multiple additives | Surface quality |
Science Direct
Analysis of hybrid HA/CNT suspended-EDM process and multiple-objectives optimization to improve machining responses of 316L steel
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Web of Science | 25 |
| Scopus | 34 |
| Google Scholar | 39 |