Machinability analysis of nickel-based superalloy Nimonic 90: a comparison between wet and LCO2 as a cryogenic coolant
Yazarlar (8)
Tej Patel
Institute Of Infrastructure, Technology, Research And Management, Hindistan
Institute Of Infrastructure, Technology, Research And Management, Hindistan
Navneet Khanna Institute Of Infrastructure, Technology, Research And Management, Hindistan
Sahıtya Yadav
Institute Of Infrastructure, Technology, Research And Management, Hindistan
Institute Of Infrastructure, Technology, Research And Management, Hindistan
Prassan Shah
Institute Of Infrastructure, Technology, Research And Management, Hindistan
Institute Of Infrastructure, Technology, Research And Management, Hindistan
Prof. Dr. Murat SARIKAYA Sinop Üniversitesi, Türkiye
Dılpreet Sıngh
Central Mechanical Engineering Research Institute India, Hindistan
Central Mechanical Engineering Research Institute India, Hindistan
Munish Kumar Gupta
Shandong University, Çin
Shandong University, Çin
Nıtın Kotkunde
Birla Institute Of Technology And Science, Pilani, Hindistan
Birla Institute Of Technology And Science, Pilani, Hindistan
| Makale Türü | Özgün Makale (SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale) | ||
| Dergi Adı | International Journal of Advanced Manufacturing Technology (Q2) | ||
| Dergi ISSN | 0268-3768 Dergi Bilgileri (2021) | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | Türkçe | Basım Tarihi | 01-2021 |
| Cilt / Sayı / Sayfa | 113 / 11 / 3613–3628 | DOI | 10.1007/s00170-021-06793-1 |
| Makale Linki | http://dx.doi.org/10.1007/s00170-021-06793-1 | ||
| UAK Araştırma Alanları |
Üretim Teknolojileri
|
||
| Özet |
| The usage of cryogenic fluid is increasing in the machining industries especially to cut the materials having a lower machinability like Nimonic 90, a nickel-based alloy. However, the comparison of flood coolant and LCO2 as a cryogenic fluid based on machining performance has not been found for machining Nimonic 90. In this regard, this study compares LCO2 and conventional mineral oil-based flood coolant on the basis of machining performance while turning Nimonic 90. The effect of turning process parameters (cutting speed (vc), feed (f), and depth of cut (ap)) and cutting fluids has been identified by analyzing machinability indicators like cutting force, flank tool wear, power consumption, surface roughness in terms of Ra, and chip morphology. Increment of 34%, 25%, and 24% in cutting forces has been observed for cryogenic turning using LCO2 in comparison with wet machining when the values of ap are 0 … |
| Anahtar Kelimeler |
| Cryogenic machining | Machinability indicators | Nickel-based superalloy | Wet machining |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Web of Science | 28 |
| Scopus | 32 |
| Google Scholar | 37 |