Investigating the Dimensional Accuracy and Surface Roughness for 3D Printed Parts Using a Multi-jet Printer
Yazarlar (5)
Ramesh Chand
Dr. B.R. Ambedkar National Institute Of Technology, Hindistan
Dr. B.R. Ambedkar National Institute Of Technology, Hindistan
Vishal S. Sharma
Dr. B.R. Ambedkar National Institute Of Technology, Hindistan
Dr. B.R. Ambedkar National Institute Of Technology, Hindistan
Rajeev Trehan
Dr. B.R. Ambedkar National Institute Of Technology, Hindistan
Dr. B.R. Ambedkar National Institute Of Technology, Hindistan
Munish Kumar Gupta
Opole University Of Technology, Polonya
Opole University Of Technology, Polonya
Prof. Dr. Murat SARIKAYA Sinop Üniversitesi, Türkiye
| Makale Türü |
Özgün Makale
(SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale)
|
||
| Dergi Adı | Journal of Materials Engineering and Performance (Q3) | ||
| Dergi ISSN | 1059-9495 Dergi Bilgileri (2023) | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | İngilizce | Basım Tarihi | 07-2023 |
| Cilt / Sayı / Sayfa | 32 / 3 / 1145–1159 | DOI | 10.1007/s11665-022-07153-0 |
| Makale Linki | http://dx.doi.org/10.1007/s11665-022-07153-0 | ||
| UAK Araştırma Alanları |
Üretim Teknolojileri
|
||
| Özet |
| The shortcoming of conventional manufacturing (CM) is that it cannot manufacture geometrically complex parts with high repeatability and good surface properties. In order to overcome these shortcomings of CM, additive manufacturing (AM) is the major alternative to the CM. However, the usefulness and performance of parts manufactured through AM are closely correlated with dimensional accuracy and surface roughness, SR (Ra). Therefore, an investigation was carried out in this study for dimensional accuracy and surface roughness of 3D printed parts fabricated in different orientations. In the investigation, four orientation patterns are considered. The part is lying on the base (A), part is lying on the long edge (B), part is lying on the short edge (C), and the part is inclined to 45°(D) to the surface of the base plate (refer to Fig. ). Orientations, i.e., A, B, C, and D, were explored for the variations in dimensional … |
| Anahtar Kelimeler |
| 3d printing | additive manufacturing | dimensional accuracy | multi-jet printing | rapid prototyping | surface roughness |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Web of Science | 47 |
| Scopus | 50 |
| Google Scholar | 62 |